Your shopping cart is empty!PYIPSS 02-138-212 PYI - PSS Shaft Seal #02-138-212 Shaft Size - 1.375" Stern Tube Diameter - 2.500"- 2.625" The PSS .. Category: Anvils Product #: PSS 02-138-2120 stars, based on 0 reviews Regular price: $264.00 $$264.00 Available from: GPC Condition: excellent conditionIn StockPYI - PSS Shaft Seal #02-138-212 Shaft Size - 1.375" Stern Tube Diameter - 2.500"- 2.625"
- Toll Free: 800-313-6025
The PSS Shaft Seal is the number one selling marine mechanical seal worldwide and is installed as standard equipment by many of the worlds most reputable boat builders / yards. The PSS Shaft Seal is also recognized as the premiere retrofit (aftermarket) seal on the world market. Certified by Bureau Veritas, ABS & Rina: Boat builders / yards recognize the advantages and value of installing the PSS as it eliminates the maintenance, constant adjustment & cost associated with traditional packing type glands. Aside from these benefits, the PSS Shaft Seal helps to eliminate water in the bilge (100% water tight) & wear to the propeller shaft. The PSS Shaft Seal can be easily retrofitted and is available for shafts ranging from 3/4" (20mm) to 6" (150mm).
The PSS Shaft Seal is a mechanical face seal that is created between the flat surfaces of the rotating stainless steel rotor and the stationary carbon flange. The stationary carbon flange is attached to the vessels stern tube with hose clamps and the carbon flange is attached to the front side of the bellows with hose clamps. The stainless steel rotor is fit on the shaft in front of the carbon flange. The stainless steel rotor is used to compress the bellows before the collar is secured to the shaft with set-screws. This compression (pre-load) maintains contact between the faces and allows the PSS to compensate for the thrust from the propeller. The carbon flange is bored larger than the shaft diameter allowing it to “float” around the shaft and thus compensate for most misalignment and vibration problems. The stainless steel collar is sealed to the shaft by two o-rings that are recessed into the bore of the collar. These o-rings rotate with the shaft and stainless steel rotor and do not experience wear during operation.Please fill in the form below:
* Required fields
Want to be sure you’re paying the lowest price?
We guarantee it.
We are doing everything possible to provide you the best products at the lowest prices possible. Due to the high number of products in our store it is possible some of the prices on our products are not up to date.
If you find one of our products with a lower price than ours, please use this form. We will compare the prices and will offer you the product at the same price!
*Valid for U.S. websites only!
Size Shaft Size 1.375" ( 1-3/8" ) Stern Tube Outside Dia. 2.500" - 2.625"